Powerware 9125 Two-in-One UPS 2500 - Manual (Page 31)

INSTALLATION
EATON Powerware ® 9125 Two-in-One UPS (2500/3000 VA) User’s Guide S 164201374 Rev D
www.powerware.com
25
Plug-Receptacle UPS Installation
NOTE Do not make unauthorized changes to the UPS or accessories; otherwise, damage
may occur to your equipment and void your warranty.
Figure 18 shows a typical installation only. See “UPS Rear Panels” on
page 33 for the rear panel of each model.
To install a plug-receptacle UPS:
1. If you are installing power management software, connect your
computer to the UPS communication port using the supplied
communication cable.
Power Cord
Output Receptacles Communication Port
UPS
EBM
EBM
Figure 18. Typical Installation (120V UPS Model Shown)
2. Plug the equipment to be protected into the appropriate UPS output
receptacles (see page 50 for more information on load segments).
NOTE DO NOT protect laser printers with the UPS because of the exceptionally high power
requirements of the heating elements.
3. If an emergency power-off (disconnect) switch is required by local
codes, see “Remote Emergency Power-off Installation” on page 31
to install the REPO switch before powering on the UPS.