Energy star, Parallel port setup, Network port setup – Panasonic KX-P8420 User Manual
Page 107: Nergy, Net speed setting, see “network port setup” on, See “network port setup” on, And “netw, T settings, 107 setup from the front panel and websetup, Parallel port setup network port setup
107
Setup from the Front Panel and WebSetup
To conserve energy and operating cost, this printer is provided with a
programmable power save feature. The printer is factory set with the power
save feature turned on. If set to On, the printer automatically turns to energy
saving mode when there are no print jobs received or access to the front
panel for more than 30 minutes. This mode can reduce the total power
consumption of the printer to less than 35 watts. Full power mode is
restored when the printer receives a job or when you press the Menu/Exit
button or print a page at the printer.
In addition to receiving print jobs over Ethernet or Token Ring, the printer
can receive print jobs from a computer through its high-speed parallel port.
If no network card is installed, the printer is connected to a computer via the
parallel port.
Parallel Port Setup
To advance to the next screen, press the Enter button.
Enable Parallel?
Yes/No [Yes*]
Press the Enter button and select
Yes
to enable printing through the parallel
port. Press the Enter button.
Time out
5 to 100 [15*]
This screen appears only if Enable Parallel is set to
Yes
. Use this option to
specify how long the printer waits without receiving data from the parallel
port before deciding the current job is complete. Press the Enter button.
Data Mode
Binary/ASCII [ASCII*]
(
*
=Default setting)
The Network Port Setup menus allow you to specify and set up a printer
port type, including: Ethernet (if optional Ethernet card is installed), Token
Ring (if optional Token Ring card is installed), or parallel port.
NOTES:
•
Ethernet and Token Ring options appear only if an optional Ethernet or
Token Ring card is installed.
•
The settings do not become effective until the printer reboots or the
printer is turned off and on. So if you just change the settings in Network
Port Setup and do not change the settings in Network Protocol Setup, you
have to turn off and on the printer.
Before you set up the printer for a Novell IPX network, be sure you have set
up the Novell servers as described in “Setting up IPX (Novell) printing” on
E
NERGY
S
TAR
®
Parallel Port Setup
Network Port
Setup