Panasonic KX-P8420 - Manual (Page 108)

108
Setup from the Front Panel and WebSetup
Network Port Setup
To advance to the next screen, press the Enter button.
A) When the Ethernet card is installed in the printer:
Ethernet Setup
Press the Enter button to enable advance to the Ethernet Speed screen.
Press the Enter button.
Ethernet Speed
Auto-Detect/10Mbps/100Mbps [Auto-Detect*]
Select the speed at which data can be transferred over the Ethernet
network or select
Auto-Detect to automatically detect the speed at which
data can be transferred over the Ethernet network. In some cases, Auto-
Detect may not correctly detect. If it happens, specify the correct speed in
this menu or from WebSetup.
B) When the Token Ring card is installed in the printer:
Token Ring Setup
Press the Enter button to view Token Ring network options.
NOTE:
• Token Ring options appear only if an optional Token Ring card is installed.
Token Ring Speed
Auto-Detect/4 Mbps/16 Mbps [Auto-Detect*]
Select a speed at which data can be transferred over the Token Ring
network, or select
Auto-Detect to automatically detect the speed at which
data can be transferred over the Token Ring network.
Max. Frame Size
632/1130/2154/4202 [4202*]
Select a frame size for Token Ring communication.
Source Routing
Yes/No [No*]
Select YES to allow the packet to travel to its destination through routers on
the network. The packet’s source, specified using the routing options listed
below, dictate the route that the packet will take. Select
No for transparent
(no source) routing.
NOTE:
• Req. All Route and Resp. All Route are displayed only when YES is
selected in Source Routing .
( * =Default setting)