Panasonic KX-P8420 - Manual (Page 86)

86
Installing Software for Windows
■ Setting up TCP/IP and LPR printing with Windows NT 4.0
Once you have installed the PostScript driver for Windows NT 4.0 complete
the setup for the TCP/IP and lpr connection as follows:
• Prepare the KX-P8420 to accept print jobs using TCP/IP and lpr
protocols.
• Configure the workstation for the TCP/IP connection.
Before you continue, ask the system administrator for the IP address
assigned to the KX-P8420 and the subnet mask as well as gateway
address, if they are used.
To prepare the KX-P8420 for TCP/IP and LPR printing:
1 With the KX-P8420 turned off, connect it to the network.
2 Turn on the printer.
Wait until Ready or Ready(Sleep) is displayed.
3 Press the Menu/Exit button of the printer’s front panel.
4 Press the Continue/Forward or Cancel/Left button to
advance to Network Protocol Setup menu.
5 Enable TCP/IP and enter the appropriate settings for
IP address, subnet mask and gateway address.
For details, see “Network Protocol Setup” on page 109 .
6 Press the Menu/Exit button to exit the setup menus.
The TCP/IP Protocol and Microsoft TCP/IP Printing software should already
be installed on the workstation for Windows NT 4.0.