Paxar Mobile Printing Station Monarch 9476 - Manual (Page 30)

1. Insert two M3.5 washers and two 10mm shoulder screws
into the sides of the printer as shown and tighten with a
screwdriver. (Figure 17.)
2. The power packs for the printers are attached to the
Station’s top shelf. Insert the tabs on the power pack into
the slots of the battery well in the base of the printer.
Push down until the latch snaps into place. (Figure 18.)
Figure 17
Shoulder
Screw
Figure 18
Power
Pack
Battery
Well
9476 Assembly and Setup Instructions
1-24