Paxar Mobile Printing Station Monarch 9476 - Manual (Page 36)

2. Center a strip of supply over the supply deflector. The
supply deflector’s rubber O-rings must be positioned
inside the edges of the supply. (Figure 25.) If you do not
need to adjust the position of the O-rings, skip to step 6.
3. Lift one end of the supply deflector to remove it from the
supply well. You may have to gently spread the supply
holders apart to release the supply deflector. (Figure 25.)
4. Roll the O-rings out of their tracks and into the new
positions.
5. Replace the supply deflector in the supply well.
(Figure 25.)
Figure 25
Supply
Deflector
O-Ring
9476 Assembly and Setup Instructions
2-4