Panasonic PT-AE900U - Manual (Page 27)

52-E NGLISH E NGLISH -53
Adjustments
and
settings
AUTO SEARCH
This should normally be set to “ON”.
ON
When the power is turned on, the
projector detects which signal is
being input, and uses that signal for
projection.
OFF
Use this setting when you do not
want the signal source to be
changed automatically when the
power is turned on.
BACK COLOR
This sets the color which is
projected onto the screen when no
signal is being input to the projector.
STARTUP LOGO
ON
The “Panasonic” logo will be
displayed when the power is turned
on.
OFF
The “Panasonic” logo will not be
displayed when the power is turned
on.
DESK/CEILING
This setting should be changed in
accordance with the projector
setting-up method. (Refer to page 18.)
DESK
When the projector is placed on a
desk or similar.
CEILING
When the projector is suspended
from a ceiling using the ceiling
bracket (sold separately).
FRONT/REAR
This setting should be changed in
accordance with the projector
setting-up method. (Refer to page 18.)
FRONT
When the projector is placed in front
of a screen.
REAR
When using a translucent screen.
OFF TIMER
The projector will return to standby
mode after the duration of the
period you set has passed. The
period can be set from 60 minutes
to 240 minutes in 30 minute
intervals. The remaining time will be
displayed 3 minutes before the
projector returns to standby mode.
The setting will be cancelled if set to
“OFF” before reaching the duration
of the period you set.
FAN CONTROL
Set “FAN CONTROL” to “HIGH”,
when using this projector at high
elevations (above 1 400 m) only.
LAMP POWER
This setting changes the lamp
brightness. When set to “LOW”, the
luminance of the lamp is reduced,
but the projector uses less power,
and the operating noise is also
reduced.
The “LOW” setting is recommended
for narrow rooms where a high
picture luminance is not essential or
for watching movies.
LAMP RUNTIME
This setting displays the usage time
for the lamp unit which is currently
being used. When replacing the
lamp unit, follow the instructions on
page 58, and reset “LAMP
RUNTIME” to “0”.
NOTE:
B The lamp’s operating life varies
depending on the usage
conditions (such as the “LAMP
POWER” setting and the
number of times the power is
turned on and off).
NOTE:
B “LAMP POWER” cannot be set
when no signal is being input.