Nortel Networks 8000 Series - Manual (Page 21)

8000 Series DC power supplies 21
Installing a DC Power Supply in an Ethernet Routing Switch 8000 Series Chassis
The 8000 Series chassis ships with no installed power supplies. Install the first
power supply in the leftmost bay. Power supply bays are numbered 1, 2, and 3 left
to right as viewed from the front of the chassis for the 8006, 8010, and 8010co.
For instructions on how to install the power supplies, see
“Installing the DC power
supply” on page 32 .
The 8002DC power supply is discontinued. The 8004DC or 8005DC power
supply replaces the 8002DC power supply. For information on the 8002DC power
supply, see the Ethernet Routing Switch 8600 Software Release 4.1
documentation.
8004DC power supply
Each 8004DC power supply provides 850 watts (W) of power to the switch.
Figure 1 shows the 8004DC power supply used in the 8006, 8010, and 8010co
chassis.
Note: The 8002DC power supply has not been tested with Ethernet
Routing Switch 8600 modules released since 8600 Release 3.7.
Therefore, Nortel recommends that you use the 8004DC or 8005DC
power supply with these modules.