Nortel Networks 8000 Series - Manual (Page 29)

Adding and replacing DC power supplies 29
Installing a DC Power Supply in an Ethernet Routing Switch 8000 Series Chassis
Removing and installing a power filler panel
A power filler panel maintains the proper cooling airflow in the 8000 Series
chassis. When you install a power supply in a bay for the first time, you must first
remove the power filler panel from the power bay. If you remove a power supply
from the chassis without replacing it, you must install a power filler panel.
To remove a power filler panel:
1 For the 8010co chassis, remove the bottom front bezel.
For instructions, see “Removing the bottom bezel (8010co chassis)” on
page 28 .
2 Using a Phillips screwdriver, loosen the two captive screws that secure the
power filler panel to the chassis until the power filler panel disengages
(
Figure 4 and Figure 5 on page 30 ).
Figure 4 Removing a power filler panel: 8010co chassis
10416FA