Nortel Networks 8000 Series - Manual (Page 30)

30 Adding and replacing DC power supplies
313070-E Rev 00
Figure 5 Removing a power filler panel: 8006 and 8010 chassis
3 Pull the power filler panel out of the chassis.
To install a power filler panel:
1 For the 8010co chassis, remove the bottom front bezel.
For instructions, see “Removing the bottom bezel (8010co chassis)” on
page 28 .
2 Place the power filler panel in the empty power supply bay ( Figure 6 on
page 31 and Figure 7 on page 31 ).
3 Tighten the 2 captive screws until the power filler panel is seated firmly.
Caution: Save the power filler panel in case you need to operate the
8000 Series chassis with a power supply removed.
8957FBO