NETGEAR Cable/DSL ProSafe Firewall FR328S - Manual (Page 17)

FR328S ProSafe Firewall with Dial Back-Up Reference Manual v2
Introduction 2-3
M-10207-01, Reference Manual v2
• Automatic Configuration of Attached PCs by DHCP
The FR328S dynamically assigns network configuration information, including IP, gateway,
and domain name server (DNS) addresses, to attached PCs on the LAN using the Dynamic
Host Configuration Protocol (DHCP). This feature greatly simplifies configuration of PCs on
your local network.
• DNS Proxy
When DHCP is enabled and no DNS addresses are specified, the firewall provides its own
address as a DNS server to the attached PCs. The firewall obtains actual DNS addresses from
the ISP during connection setup and forwards DNS requests from the LAN.
• PPP over Ethernet (PPPoE)
PPP over Ethernet is a protocol for connecting remote hosts to the Internet over a DSL
connection by simulating a dial-up connection. This feature eliminates the need to run a login
program such as EnterNet or WinPOET on your PC.
• PPTP login support for European ISPs, BigPond login for Telstra DSL in Australia.
• Dynamic DNS
Dynamic DNS services allow remote users to find your network using a domain name when
your IP address is not permanently assigned. The firewall contains a client that can connect to
many popular Dynamic DNS services to register your dynamic IP address.
Configurable Auto Uplink™ Ethernet Connection
With its internal 8-port 10/100 switch, the FR328S can connect to either a 10 Mbps standard
Ethernet network or a 100 Mbps Fast Ethernet network. Both the local LAN and the Internet WAN
interfaces are autosensing and capable of full-duplex or half-duplex operation.
The firewall incorporates Auto Uplink TM technology. Each LOCAL Ethernet port will
automatically sense whether the Ethernet cable plugged into the port should have a ‘normal’
connection such as to a PC or an ‘uplink’ connection such as to a switch or hub. That port will then
configure itself to the correct configuration. This feature also eliminates the need to worry about
crossover cables, as Auto Uplink will accommodate either type of cable to make the right
connection.
Easy Installation and Management
You can install, configure, and operate the FR328S within minutes after connecting it to the
network. The following features simplify installation and management tasks: