National Instruments GPIB-PC - Manual (Page 89)

BASICA/QuickBASIC GPIB-PC Function Calls Section Four A
GPIB-PC User Manual 4A-14 ©National Instruments Corp.
Table 4A.4 - QuickBASIC Version 4.0 GPIB-PC Functions
Description Function Syntax
Change access board of device ILBNA (BD%,BNAME$)
Become Active Controller ILCAC (BD%,V%)
Clear specified device ILCLR (BD%)
Send commands from string ILCMD (BD%,CMD$,CNT%)
Send commands asynchronously from
string
ILCMDA (BD%,CMD$,CNT%)
Enable/disable DMA ILDMA (BD%,V%)
Change/disable EOS mode ILEOS (BD%,V%)
Enable/disable END message ILEOT (BD%,V%)
Open device and return unit descriptor ILFIND (BDNAME$,BD%)
Go from Active Controller to standby ILGTS (BD%,V%)
Set/clear ist ILIST (BD%,V%)
Go to local ILLOC (BD%)
Place device online/offline ILONL (BD%,V%)
Change primary address ILPAD (BD%,V%)
Pass control ILPCT (BD%)
Parallel poll configure ILPPC (BD%,V%)
Read data to string ILRD (BD%,RD$,CNT%)
Read data asynchronously to string ILRDA (BD%,RD$,CNT%)
Read data to file ILRDF (BD%,FLNAME$)
Read data to integer array ILRDI
(BD%,IARR%(),CNT%)
Read data asynch to integer array ILRDIA
(BD%,IARR%(),CNT%)
Conduct a parallel poll ILRPP (BD%,PPR%)
Request/release system control ILRSC (BD%,V%)
Return serial poll byte ILRSP (BD%,SPR%)
Request service ILRSV (BD%,V%)
Change secondary address ILSAD (BD%,V%)
Send interface clear ILSIC (BD%)
Set/clear remote enable line ILSRE (BD%,V%)
Abort asynchronous operation ILSTOP (BD%)
Change/disable time limit ILTMO (BD%,V%)
Trigger selected device ILTRG (BD%)
(continues)