National Instruments PXI NI 8171 Series - Manual (Page 69)

© National Instruments Corporation I-1 NI 8171 Series User Manual
Index
A
Advanced Setup menu, 2-5
B
BIOS
checking settings, 4-1
flashing new BIOS, 4-7
power loss during update, 5-3
setup
Advanced Setup menu, 2-5
Boot Setup menu, 2-8
DMI Event Logging menu, 2-5
entering, 2-3
Exiting BIOS Setup menu, 2-9
Integrated Peripherals menu, 2-6
Main Setup menu, 2-4
PXI Setup menu, 2-7
Security Setup menu, 2-8
boot options
configuring controller, 4-2
Boot Setup menu, 2-8
C
CD-ROM drive
for PXI-1020 and PXI-1025, 2-11
installing software from, 4-3
chip set north bridge, 1-4
chip set south bridge, 1-4
CMOS
clearing contents (figure), 2-10
setting back to default, 5-2
COM1 and COM2 connectors
connector locations and pinout (figure), 3-3
connector signals (table), 3-3
common configuration questions
boot options, 4-1
cables and connections, 4-2
chassis configuration, 4-5
driver installation, 4-3
general questions, 4-1
hard drive recovery, 4-4
operating system, 4-3
PXI configuration, 4-8
upgrade information, 4-6
Windows NT4, 4-8
CompactPCI specification, 1-1
ComponentWorks, 1-6
ComponentWorks++, 1-6
configuration
common questions
boot options, 4-1
cables and connections, 4-2
chassis configuration, 4-5
driver installation, 4-3
general questions, 4-1
hard drive recovery, 4-4
operating system, 4-3
PXI configuration, 4-8
upgrade information, 4-6
Windows NT4, 4-8
connectors
COM1 and COM2 connectors and
signals, 3-3
Ethernet connector and signals, 3-4
GPIB connector and signals, 3-10
parallel port connector and signals, 3-5
peripheral expansion overview (table), 3-1
PS/2 connector and signals, 3-8
trigger connector and signals, 3-9