NetComm HS800 - Manual (Page 55)

Rev. 1 - YML698 www.netcomm.com.au
HS800 User’s Guide Page 55
You have a connection to the Internet via your modem and you can surf using devices that
are connected to the LAN side of the HS800 (default IP’s in the 10.0.0.x range)
You would like to specify certain IP addresses that can administer the HS800 both from the
LAN and WAN (outside of office) side.
Login to http://10.0.0.1/ as the administrator and navigate to Advanced Setup / System and
scroll down to following section:
Click on Specify
List IP addresses that will allow people to access HS800 login screen and click the Apply
button. In this example three IP’s are able to access the HS800: 10.0.0.2, 10.0.0.3 and
202.44.165.195. The first two are on the LAN side of the HS800 and the last one is the
WAN IP of the other machine (i.e. another PC outside the office network).
To find out the IP if the PC is located on an intranet with an address in the private IP range
(most common case), you can browse to the following address from the remote PC:
http://www.whatismyip.com/
You cannot browse to 10.0.0.1 from the 202.. machine. You need to find out the IP the
modem/router/ISP has allocated to the HS800. To find this, you click on System Quick View
in the bottom left of the screen:
You will see the System Status screen. The section you are concerned with is: