NetComm HS800 - Manual (Page 8)

www.netcomm.com.au Rev. 1 - YML698
Page 8 HS800 User’s Guide
1-4-2 Rear Panel
The rear panel of the HS800 Wireless Gateway is shown below.
Figure 1-3 HS800 Wireless Gateway Rear Panel
1. Power Jack: Used to connect the external power supply with the HS800 Wireless
Gateway.
2. LAN Ports:
The rear panel supports four auto-sensing RJ-45 ports and all ports can be auto-switched
to MDI-II connections. The LAN ports are used for linking hosts or other network
devices. The individual port can be either connected to 100BaseTX networks or
10BaseT networks. When connecting to a 100BaseTX network, the ports operate at
100Mbps in half-duplex mode or 200Mbps in full-duplex mode. When connecting to a
10BaseT network, the ports operate at 10Mbps in half-duplex mode or 20Mbps in full-
duplex mode.
3. WAN Port: One Ethernet port used for linking a xDSL or Cable Modem.
4. Device Port: Used to connect the Account Generator Printer.
1. 2. 3. 4.