NetComm NTC-990 - Manual (Page 54)

In the VRRP Configuration section on the Routing HTML page:
Click enable
Enter the relevant details
• enter an id – this is the VRRP id which is different for each virtual router on the network.
• enter a priority – a higher value is a higher priority.
• enter the VRRP IP address – this is the virtual IP address that both virtual routers share.
Hit Save
NOTE – configuring VRRP changes the MAC address of the Ethernet port and therefore if you want to
resume with the web configuration you must use the new IP address (VRRP IP) or on a command prompt
type: arp –d <ip address> (i.e arp –d 192.168.1.50) to clear the arp cache.(old MAC address).
Revision 1.55 NetComm Limited
March 2009
53