NetComm NTC-990 - Manual (Page 8)

3 What you will need to configure the Cellular Router
You will need the following hardware components to set up the Cellular Router:
Power Supply (8-28VDC)
Ethernet cable
Laptop or PC.
Active Telecommunications carrier SIM card (USIM)
NOTE – The Ethernet port on the Cellular Router is a DTE non-auto switch so you will need a crossover
cable if connected directly to your PC. However, if there is a Hub/Switch connected between the Cellular
Router and PC you will need to use a straight through cable.
How to access the Cellular Router using the Web Browser
Install the supplied antenna to the Cellular Router. This needs to be screwed to the RF Antenna connector.
• For 850MHz networks use the Black antennas provided
• For 900MHz networks use the Black antennas provided
• For 2100/1900MHz networks use the Gray antenna provided
Connect power adapter to the mains and plug the output jack to the power jack of the Cellular Router. The
green Power LED on the panel should illuminate.
Connect an Ethernet crossover cable or straight through cable as appropriate between the Cellular
Router’s Ethernet connector and the Ethernet Connector on your PC or switch. Configure your PC’s
Ethernet interface to be dynamically assigned an IP address by doing the following:
Revision 1.55 NetComm Limited
March 2009
7