Nikon WT-3 - Manual (Page 19)

11
Copying Network Profi les to the Camera
Profi les for network computers, ftp servers, and printers can be copied to the cam-
era using the WT-3 Setup Utility. The WT-3 Setup Utility is required for connection
to a computer in transfer, PC, and print modes. Either the WT-3 Setup Utility or the
camera menus ( 48) can be used for connection to ftp servers in transfer mode.
Supported Operating Systems
The WT-3 Setup Utility is compatible with Mac OS X version 10.3 or later (Power PC G4/G5
CPUs only) or a pre-installed version of Windows XP Service Pack 1 or later (Service Pack 2
recommended).
Before starting the WT-3 Setup Utility, ensure that the camera battery is fully charged
or the optional EH-6 AC adapter is connected.
1 Set the camera USB option to PTP.
1.1 Turn the camera on.
1.2 Select the USB in the camera setup menu and
choose PTP.
2 Connect the UC-E4 USB cable supplied with the camera.
2.1 Turn the camera off .
2.2 Connect the UC-E4 as shown at right.
Connecting the USB Cable
The USB cable can also be connected when the WT-3 is attached. Disconnect the WT-3 USB
cable and connect the UC-E4 to the camera as described above.