Nikon WT-3 - Manual (Page 36)

28
Controlling the Camera Using Nikon Capture 4
Ethernet Networks: Do Not Disconnect the Ethernet Cable
Do not disconnect the Ethernet cable while the camera is on.
Wireless Networks: Loss of Signal During Transfer
A loss of signal may interrupt the connection while pictures are being transferred to Nikon
Capture 4 Camera Control. If the POWER LED on the WT-3 is blinking ( 29), select Off for the
Wireless transmitter > Wireless LAN system option in the camera setup menu and then
select On again. Transfer will resume when the connection is re-established. Do not turn the
camera off . Transfer can not be resumed once the camera is turned off .
1 Complete the steps in “Connecting to a Computer” ( 26).
2 Start Nikon Capture 4 Camera Control on the host
computer and confi rm that is displayed in the
camera control panel.
3 Control the camera as described in the
Nikon Cap ture 4 User’s Man u al. Any
photographs taken while the camera is connected will be recorded directly
to the computer hard disk.