National Instruments NI WLS/ENET-9163 - Manual (Page 14)

NI WLS/ENET-9163 Carrier User Guide and Specifications 14 ni.com
Device Interface
Figure 7 shows the NI WLS/ENET-9163 carrier interface.
Figure 7. NI WLS/ENET-9163 Carrier Interface
Reset Button
The NI WLS/ENET-9000 Series devices are equipped with a reset button
as shown in Figure 7.
Pressing the reset button results in the following device responses:
• When pressed for less than 5 seconds, the device reboots with the
current configuration.
• When pressed for 5 seconds or longer, the STATUS LED turns on.
When released, the device reboots into Factory Default Mode, which
returns the device user configuration to the factory-set defaults.
1 RJ-45 Ethernet Port
2 LEDs: WLS LINK*, ACTIVE,
STATUS, and POWER
3 Reset Button
4 Trigger Connector
5 10/100 LED
6 LINK/ACT LED
7 Power Connector
* NI WLS-9163 Carrier Only.
NI WLS-9163
802.11g C Series Carrier
INPUT 9-30 V
4.5 W MAX
10/100 LINK/ACT
V C
PFI0
PFI1 GND
RESET
GND
WLS LINK
ACTIVE
STATUS
POWER
1
4 7
3
2
6 5