Module i/o states, Power requirements, Physical characteristics – National Instruments NI WLS/ENET-9163 User Manual

Page 27: Antenna

Advertising
background image

© National Instruments Corporation

27

NI WLS/ENET-9163 Carrier User Guide and Specifications

Module I/O States

At power-on ........................................... Module-dependent. Refer to the

documentation included with the
C Series I/O module.

Power Requirements

Caution

You must use a National Electric Code (NEC) UL Listed Class 2 power supply

with NI WLS/ENET-9000 Series devices.

Note

Some C Series I/O modules have additional power requirements. For more

information about the C Series I/O module power requirements, refer to the documentation
included with the C Series I/O module.

Input voltage range................................. 9 V to 30 V

Maximum required input power ............ 4.5 W

Power input mating connector ............... 2 position combicon, Phoenix

Contact part number: 1714977

Physical Characteristics

Weight .................................................... Approx. 242 g (8.5 oz)

Weight with antenna
(NI WLS-9163 Only) ............................. Approx. 256 g (9 oz)

Dimensions............................................. 182 mm

× 95 mm × 37 mm

(7.18 in.

× 3.75 in. × 1.50 in.)

With rubber feet attached ....................... +3.56 mm (+0.140 in.)

Antenna

Antenna connector
(antenna not attached) ............................ +5.71 mm (+0.225 in.)

Attached, fully extended ........................ +108.7 mm (+4.28 in.)

Note

Refer to the

Dimensions

section for device dimensions with the antenna attached.

Advertising