Net Optics Smart Filtering none - Manual (Page 16)

12
*** Confidential - DO NOT Distribute ***
Director
Plan the Installation
Before you begin the installation of your Director device, determine the following:
Name that will identify the Director device •
IP address of the Director device, or • a range of IP addresses if you are deploying multiple Director devices
Net Mask for Director •
IP address of the remote management console, if deployed over a WAN; this address is used for SNMP traps •
Gateway to the remote management console, if deployed over a WAN •
Port assignments and filters for the Network and Monitor port connections •
Make sure you have a suitable location to install the Director device. For power redundancy, use two independent
power sources.
Unpack and Inspect the Director device
Carefully unpack the Director device, power supplies, and all cables that are provided. Director is delivered with the
following:
(1) Director device •
(2) Power cords •
Director Quick Install Guide (one sheet) •
(1) CD containing the Director User Guide (this document) •
Network and monitor cables •
RS-232 DB9 cable for use with the CLI •
Extended Warranty if purchased •
Check the packing slip against parts received. If any component is missing or damaged, contact Net Optics Customer
Service immediately at +1 (408) 737-7777. (Note: XFP modules are ordered and shipped separately.)