Net Optics Smart Filtering none - Manual (Page 35)

31
*** Confidential - DO NOT Distribute ***
Director
Work with configurable 10 Gigabit ports
The two configurable 10 Gigabit XFP ports on the front panel are designated t.1 (on the left) and t.2 (on the right). They
can be used in network port lists and monitor port lists. The 10 Gigabit ports are configured for Network or Monitor as
required by the filter add commands you enter. Some examples follow. If separate filter add commands require differ-
ent configurations for the same XFP port, the port is configured as required for the command that was entered last.
To use both XFP ports as Network ports:
Enter 1. filter add in_ports=t.1 ip_proto=6 action=redir redir_ports=m.1. A filter has been defined to select all IPv4
TCP packets from 10 Gigabit Port 1 and copy them to Monitor Port 1.
Enter 2. filter add in_ports=t.1 ip_proto=17 action=redir redir_ports=m.2. A filter has been defined to select all IPv4
UDP packets from 10 Gigabit Port 1 and copy them to Monitor Port 2.
Enter 3. filter add in_ports=t.2 action=redir redir_ports=m.3. A filter has been defined to copy all traffic from10
Gigabit Port 2 to Monitor Port 3.
Enter 4. filter commit. The filters are activated.
filter add t.1 ip_proto=17 action=redir redir_ports=m.2
filter add t.2 action=redir redir_ports=m.3
filter add t.1 ip_proto=6 action=redir redir_ports=m.1
XFP Port 2 Monitor Port 3
Monitor Port 1
XFP Port 1
Monitor Port 2
Protocol =
TCP
Protocol =
UDP
Configurable 10 Gigabit XFP ports used as Network ports Figure 31:
To use both XFP ports as Monitor ports:
Enter 1. filter add in_ports=n1.1-n1.4 action=redir redir_ports=t.1. A filter has been defined to aggregate the traffic
from the first four 1 Gigabit Network Ports and copy the aggregated traffic to 10 Gigabit Port 1.
Enter 2. filter add in_ports=n1.11 action=redir redir_ports=t.2. A filter (switch) has been defined to copy all the traffic
from 1 Gigabit Network Port 11 to 10 Gigabit Port 2.
Enter 3. filter commit. The filters are activated.