Nortel Networks Passport Module 8672A - Manual (Page 125)

Chapter 6 Configuring the Passport 8672ATM Module 125
Using the Passport 8672ATM Module
The Insert ATM 1483 ELAN dialog box opens ( Figure 22 on page 67 ).
Table 13 on page 68 describes the Insert ATM 1483 ELAN dialog box fields.
4 Do the following:
a In the Port field, click the button to view ports.
b Select the port for which you configured the ATM PVC in “Configuring
two ATM 1483 PVCs on the same ATM port” on page 127 .
c In the VlanId field, enter the VLAN Id you created in “Creating a VLAN
“byPort” and adding ports” on page 119 .
d In the PvcIds field, enter the value for the PVC IDs you created in
“Configuring two ATM 1483 PVCs on the same ATM port” on page 127 .
e In the ConnectType field, select bridged.
5 Click Insert.
The Insert ATM 1483 ELAN dialog box closes, and the ATM 1483 ELAN tab
is redisplayed.
6 Click Close.
Bridging point-to-point traffic using an ATM 1483 PVC using
the CLI
To configure the Passport 8672ATM Module for ATM 1483 PVCs for VLANs
bridged across an ATM PVC network, using the CLI:
1 To create a VLAN by port, enter:
config vlan 2 create byport 1
2 To add an ATM port (in this example, 1/1) and several Ethernet ports (in this
example, 3/40 to 3/48) to the VLAN, enter:
config vlan 2 port add 1/1, 3/40-3/48
3 To configure an ATM 1483 PVC for null-encapsulation and ubr, enter:
config atm 1/1 pvc create 0.100 enc 1483-null serv
ubr
Alternatively, to configure an ATM 1483 PVC for null-encapsulation and vbr,
enter: