Nortel Networks Passport Module 8672A - Manual (Page 85)

Chapter 5 Managing the Passport 8672ATM Module with the CLI 85
Using the Passport 8672ATM Module
show ports info atm ports command
This command displays information (Figure 29) about the configuration of ATM
ports. The command uses the syntax:
show ports info atm ports
Figure 29 show ports info atm ports command output
ENCAPS Encapsulation methods: either null, or llc-snap.
SERVICE TYPE Unspecified bit rate (ubr) or variable bit rate (vbr).
VLAN ID VLAN name to which the ELAN belongs.
PVC LIST List of permanent virtual circuits.
VLAN MAC ADDRESS The MAC address assigned to this VLAN (used in IP and
IPX routed circuits when there is no appropriate destination
MAC to use).
LOCAL IP ADDRESS The local Ip address for connection type IP.
REMOTE IP ADDRESS The remote Ip address for connection type IP.
IPX NETWORK NUMBER Network number.
IPX ENCAP Encapsulation method: llc, snap, ether-ii or raw.
Table 21 Information fields for the show ports info atm all command (continued)
Field Description
Passport-8610:5/show/ports/info/atm# ports
=======================================================================
ATM Port Configuration
=======================================================================
PORT MDA SCRAMBLE FRAMING MAX-BITS CLOCK LOOPBACKADMIN STATUS
NUM DESCRIPION ENABLE MODE VPI VCI SOURCE MODE STATE
-----------------------------------------------------------------------
3/1 OC-12c MM enable SONET 4 9 free off up up
3/5 Quad OC-3c MM enable SONET 2 9 free off up up
3/6 Quad OC-3c MM enable SONET 2 9 free off up down
3/7 Quad OC-3c MM enable SONET 4 7 free off up up
3/8 Quad OC-3c MM enable SONET 4 7 free off up up
Passport-8610:5/show/ports/info/atm#