Nortel Networks Passport Module 8672A - Manual (Page 74)

74 Chapter 5 Managing the Passport 8672ATM Module with the CLI
209195-A
This section contains the following information:
• “Configuration commands ,” next
• “Show commands” on page 82
Configuration commands
This section describes the CLI configuration commands available with the
Passport 8672ATM Module. There are three types of configuration commands:
• “Module commands ,” next
• “1483 ELAN statistics” on page 75
• “Port commands” on page 77
Module commands
The module commands allow you to:
• Reset the module
• View ELAN statistics
• Display the image filename for the Passport 8672ATM Module.
The syntax is:
config atmcard < atmslot number>
The required variable < atmslot number> is the slot number of the module in
the Passport 8600 chassis. Table 14 describes the parameters and variables for the
config atmcard command.
Note: If you replace one card with another type of card, Nortel
Networks recommends that you go to the root level of the CLI directory
before using any CLI commands.