Nortel Networks Passport Module 8672A - Manual (Page 134)

134 Chapter 6 Configuring the Passport 8672ATM Module
209195-A
5 Click Enable.
6 Click Apply.
The OSPF tab closes, and the IP Address tab is redisplayed.
7 Click Close.
Configuring a null-encapsulation PVC
See “Configuring two ATM 1483 PVCs on the same ATM port” on page 127 .
Associating the PVC with the VLAN
See “Associating the PVC with the VLAN” on page 124 .
Follow the instructions there except, in the ConnectType field, select IP instead of
bridged.
Configuring an IP routing 1483 PVC using the CLI
To configure the Passport 8672ATM Module for an ATM 1483 IP routed PVC,
using the CLI:
1 To create two VLANs by port, enter:
Metric Metric for this type of service (TOS) on this interface. The
default value of the TOS 0 Metric is (10^9 / ifSpeed). The
value FFFF means “no route via this TOS.”
AuthType Authentication type specified for an interface. Additional
authentication types may be assigned locally.
AreaId A 32-bit integer uniquely identifying the area to which the
interface connects. Area ID 0.0.0.0 is used for the OSPF
backbone.
AdvertiseWhenDown Value used indicates whether or not a VLAN state change
should be notified to layer 3, provided that the VLAN is
configured as a routable interface. Also used for single
routable ports. In that case, the criteria for state is
PortOperStatus.
Table 47 OSPF tab fields (continued)
Field Description