Nokia CC100 - Manual (Page 25)

CC100Master Bridge User’s Guide
( Incoming Source IP Address & Subnet Mask ) = ( IP Address & Subnet Mask )
For the factory default setting, it will accept all incoming packets.
For example, the following filter set permits all Hosts with IP address ‘192.168.1.xxx’ to access and configure the
CC100,
For each programmed filter set, you can further specify if the protocols Telnet/Http/SNMP/Ping are enabled or not.
Be careful not to block your current IP from accessing the CC100 remotely; else you have to press the Reset Button
locally and restart from factory default settings.
22