Nokia CC100 - Manual (Page 48)

CC100 Master Bridge User’s Guide
45
[ -c <lan1/lan2/off/del>] addresses can be setup, refer Static MAC
<mac> : max 8 entries
<lan1/lan2> : bind the current MAC entry to LAN1 or LAN2 port,
i.e. enable this MAC entry as static MAC
<off> :disable this MAC entry, neither bind to LAN1 nor LAN2
<del> : remove the current MAC entry, invalid this MAC entry to
default 00-00-00-00-00-00
swtagvlan
[ -c <on/off>]
[ -p <lan1/lan2/hpna>
[ -r <priority(0~7)>]
[ -v <vid(0~4095)>]
[ -i <all/tag>]
[ -o <untag/
tag/
bypass >]]
Display or set up the LAN1/LAN2/HCNA Tag VLAN. refer Tag
VLAN Setup for more.
<lan1/lan2/hpna> : configure LAN1 or LAN2 or HCNA port
<priority> : 802.1p value, 0~7
<vid> : 802.1Q VID, 0~4096
<all/tag> : ingress rule -- accept all incoming packets or accept
incoming tagged packets only, reject other incoming packets.
<untag/tag/bypass> : egress rule: un-tag or tag or bypass the
outgoing packet
-c: enable Tag VLAN mode or not
-p: the port in Tag VLAN mode
-r: 802.1p in Tag VLAN mode
-v: VID of 802.1Q in Tag VLAN mode
-I: ingress rule for the port in Tag VLAN mode
-o: egress rule for the port in Tag VLAN mod
tftp
-s <ip>
-c <get/put>
-f <file>
Run TFTP client to get file (upload file onto CC100) or to put
file (retrieve file from CC100) from TFTP server IP
<ip> .
<get/put> : run TFTP command ‘ get ’ or ‘ put ’
<file> : filename
time
Display current System Time.
upep
[ -a ]
[ -m <mac>]
[ -n <note>]
Upgrade EP HCNA driver (stored in Upload Area), this
operation also synchronize EP with EP
Properties Profile
stored in CC100,
-a: upgrade all on-line EP at once
-m: upgrade the EP with matched MAC
<mac>
-n: upgrade (matched MAC <mac>) EP ‘Note’ property <note>
upmaster
Upgrade Master HCNA driver (stored in Upload Area), this
operation also synchronize Master HCNA device with its setting
values in
Properties Profile .
upsys
Upgrade the uploaded system firmware (stored in Upload
Area), then reboot.
useradd
name
-p
<password>
-r <ro/rw>
Create new management user account.
name: user name
-p: login password
-r: ‘
ro ’ for user has read-only privilege, ‘ rw ’ for user has read-
write privilege
userdel
name Delete the management user account by name.
name: user name
users Display all user accounts.