Nokia CC100 - Manual (Page 45)

CC100Master Bridge User’s Guide
42
help
Display all commands with brief description
hpnareboot Reset Master HCNA device’
ipconfig
[ -a <ip>
-m <mask>
-g <default gateway>]
Display or set up system IP network, include IP address <ip> ,
subnet mask <mask> , and default gateway <default gateway> .
logserver
[ -s <set>
[ -c <act/deact>]
[ -a <ip>
-v <severity>] ]
Display or set up Unix-like Syslog servers(max 5 set)
<set> : server index, at most 5 servers (0~4)
<act/deact> : activate or de-activate the server with IP address
<ip>
<severity> : select the severity level, refer section “ System Log ”,
default level 6 ( info )
master
-k <on/off/key (0x…) > Set up Master HCNA device Privacy Mode setting values. Use
command ‘upmaster’ to take effect on Master device. (replace
the working values with the setting ones) Use command ‘upep’
to upgrade EP with the new ‘Privacy Mode/Key’.
<on/off> : set ‘Privacy Mode’ to ON or OFF, default OFF
<key (0x nnnn ) > , n is 0~F: 4-digit ‘Privacy Key’ in hexadecimal,
default 0x0
passwd
[name]
-o <oldpasswd>
-n <newpasswd>
Change user’s password, user can update its own password.
Only superuser has the privilege to rewrite other’s password,
[name] : user’s account name, default to current login name if
not supplied
<oldpasswd> : old password, superuser can bypass this
parameter
<newpasswd> : new password
ping
[ -n <count>]
[ -w <timeout>]
[ -l <pktlen>]
address
ICMP ping function,
<count> : number of ping requests(max 65535)
<timeout> : expiry timer in each reply(1~60 sec)
<pktlen> : sent packet length(64~1500)
address: target IP address
reboot
Reboot system
rmep
<mac> Remove designated EP Properties Profile .
<mac> : EP MAC <mac> to be removed
service
[ -s <telnet/http>
[ -c <on/off>]
[ -p <port ) >]
[ -t <idle>] ]
Display or set up Telnet and Http service.
<telnet/http> : configure Telnet or Http
<on/off> : enable or disable this service
<port> : TCP port number (0~65535)
<idle> : expiry timer to logoff automatically (0~32767 sec)
default 300 seconds
showep
[ -f ]
[ -n <note>]
[ -m <mac>]
Display EP connection status and properties, and check if it
matches the stored
Properties Profile in CC100.
-f: force to re-scan all connected EPs
-n: display EP with matched
<note>
-m: display EP with MAC address <mac>
showlog
Display the (Syslog) logged messages.
showmaster
Display Master HCNA information, include driver version,
properties(Privacy Mode, Privacy Key)
snmp
[ -c <act/deact>]
[ -p <port>]
[ -n <name>]
[ -t <contact>]
[ -l <location>]
[ -r <rcomm>]
[ -w <wcomm>]
Display or set up basic SNMP system configuration.
<act/deact> : activate(enable) or de-activate(disable) SNMP
agent
<port> : SNMP UDP port number (0~65535), default 161
<name> : SNMP system name
<contact> : SNMP system contact information
<location> : SNMP system location information
<rcomm> : SNMP system read-only community name, default
‘ public ’