Nokia CC100 - Manual (Page 49)

CC100Master Bridge User’s Guide
Use SNMP
The SNMP Agent resides in CC100 and will handle requests from a remote SNMP Manager. The CC100 SNMP
agent supports standard SNMP community-based operations (SNMP V1/V2c) as ‘SET’, ‘GET’ and ‘TRAP’.
You need to specify the correct Read-Only Community Name into bridge before any SNMP ‘GET’ operation can
be performed. Also set up the Read/Write Community Name for SNMP ‘SET’ operation. ‘SET’ operation can
modify the setting within the CC100. While ‘Get’ is read-only operation used to report the requested SNMP data to
SNMP manager.
You may need the accompanying proprietary MIB file for some popular SNMP/MIB manager software to manage
the bridge system. The CC100 bridge system may also be integrated into your original SNMP management system
by this MIB file.
Each SNMP manager will assign the name of the community it belongs to in its ‘GET’, ‘SET’ and ‘TRAP’
operations. The community name could be unique to allow set of SNMP managers to access one SNMP agent, any
operation with mismatched community name will be rejected by agent. For security consideration, you should either
change the factory default community name or disable SNMP function in CC100.
The default ‘GET’ community name of CC100 is ‘public’, and default ‘SET’ community name is ‘private’.
For the following example, the two ‘TRAP Server’ with IP address ‘192.168.1.100’ and ‘192.168.1.101’ will
capture all traps emitted from the CC100 SNMP agent,
46