Nike Triax Elite HRM/SDM - Manual (Page 24)

24
1
2
7
3 SEC
Linking Digital Components to the Watch
All componetns in your system share a unique digital ID to avoid crosstalk with other Triax Elite systems. Before the
components communicate properly, the watch must be linked to the HRM transmitter and SDM pod to establish this
shared ID. The original components which came with the watch were linked at the factory. Follow steps through
to re-link the original components or link any replacement components to the Triax Elite watch.
NOTE: These directions describe how to link both components. If you are replacing / re-linking only one component, you can ignore the steps
for the other component. Exit ID SENSOR LINKING once you establish a successful link with the new component.
Scroll to
PC mode.
NOTE: After steps 1 and 2 below, the watch will
begin to search for the components.
If the watch displays NO HRM or NO SDM
before you are finished with all 6 steps,
you will need to exit PC mode and re-enter
ID SENSOR LINKING.
Firmly grasp the HRM transmitter with both
hands, one on each end, making sure to touch
the sensors on the back side of the transmitter.
There is no ON / OFF switch for the transmitter.
It sends a digital signal during the first 10
seconds of connection with the sensors.
NOTE: If you are unable to enter ID SENSOR LINKING
before the 10 seconds expires, wait two minutes
for the HRM transmitter to automatically turn off
and try again.
After a few seconds the watch should display
NEW HRM. This means the watch has located
the digital ID of the HRM transmitter for the
first time.
NOTE: Once you have linked the HRM transmitter for
the first time, the watch will remember the digital ID
until you switch to a different transmitter.
If you would now exit PC mode and re-enter
ID SENSOR LINKING, the display would read
HRM instead of NEW HRM.
Using a coin, turn the SDM pod
battery hatch 90 degrees clockwise.
Insert a AAA Alkaline battery with
the negative node facing you.
Press and hold the power button on
the SDM pod for five seconds until
the LED light begins a fast triple-
flash. The pod is now in ID mode,
ready to link with the watch. After
10 seconds the pod will revert to
normal operation.
After a few seconds, the watch
should display NEW SDM under
NEW HRM. This indicates the
watch has successfully located
the digital ID of both components.
NOTE: Once you have linked the SDM
pod for the first time, the watch will
remember the digital ID until you switch
to a different pod. If you would now exit
PC mode and re-enter ID SENSOR
LINKING, the display would read SDM
instead of NEW SDM.
SENSORS
EXIT