Nike Triax Elite HRM/SDM - Manual (Page 26)

26
Troubleshooting (continued)
HRM transmitter does not link with the watch:
Make sure the watch has assigned a digital ID
to the HRM transmitter. See page 24.
Make sure the HRM transmitter is ON by placing it on the body.
The unit turns ON when it detects the two electrodes on the
body. It is recommended to wear the transmitter directly
against the skin.
Reposition the HRM transmitter slightly.
Try replacing the battery.
Check battery placement for correct orientation.
Moisten the electrodes with water or gel to make better contact
with the body. If you are wearing the HRM transmitter over
clothing, try wetting the clothing.
Re-enter CHRON or WKOUT mode to the watch.
The watch will not ID the HRM transmitter in PC adjust mode:
There is a limited time that the HRM transmitter will attempt to
syncronize with the watch.
Set the HRM transmitter aside for several minutes and try again.
Watch display is frozen:
The display of your watch may “freeze” due to static electricity
or recent battery replacement. If this occurs, press and hold all
five buttons at the same time. This will erase the data in the
memory and reset the watch to the factory settings.
Press and hold all five buttons
at the same time to reset the
watch to the factory settings
The SET WATCH and SYNC buttons are not present in the Triax
Elite application:
Exit the application. Exit PC mode. Plug-in the USB dock
to a working USB port on the computer. Open the application
again and then enter PC mode.
If you unplug the USB dock while the application is open,
you will need to reboot the computer before SYNC and SET
WATCH buttons will appear in Calendar window.
WKOUT ACTIVE or CHRONO ACTIVE shown in watch display:
The WKOUT ACTIVE or CHRONO ACTIVE display
means you must save a workout or run data before
linking to the computer. See page 15, Begin a Workout,
or page 19, Save Run Data.
Run or Workout data downloaded to wrong USER PROFILE:
Once run or workout data is uploaded to the computer,
it is permanently erased from the watch. It is also embedded
into the USER PROFILE that was active at the time of the upload.
There is no way to move it to another profile.
Make sure the current USER PROFILE is set to the desired
profile before downloading run or workout data from the watch.
Where can I locate my WORKOUTS, PLANS and USERS files:
Windows 2000 / XP:
C:\ Documents and Settings \ All Users \ Documents \ Nike \
TRIAX ELITE
Windows 98 / ME:
C:\ Program Files \ Nike \ TRIAX ELITE
Macintosh:
Main Hard-drive \ Applications \ Nike \ TRIAX ELITE
These files will be found at the path listed above unless you
chose a custom location during installation.