National Instruments NI WAP-3711 - Manual (Page 20)

NI WAP-3701/3711 User’s Manual Web Console Configuration
3-6
NOTE Although it is more convenient to use dynamic bridging, there is a limitation—the AP Client can
only transmit TCP/IP packets between its wireless interface and Ethernet interface; other types of
traffic (such as IPX and AppleTalk) are not forwarded.
TIP When the AP is configured for AP Client, it can be used as an Ethernet-to-wireless network
adapter. For example, a notebook computer equipped with an Ethernet adapter, but no wireless
card, can be connected to this device with an Ethernet cable for wireless connectivity to another
access point.
Administrative Password
On this page, you can change the user name and password. The new password must be typed twice
to confirm (note that the default user Name and Password or “admin” and “root,” respectively).
Managing the Firmware
Firmware management operations for the NI WAP-3701/3711 include “Firmware Upgrade,”
“Configuration Backup,” “Configuration Restore,” and “Configuration Reset (Factory Defaults).”
Firmware upgrade, configuration backup, and configuration restore can be achieved via HTTP or
TFTP. The HTTP-based method is suggested because it is more user friendly. However, due to the
fact that different Web browsers and versions behave differently, HTTP-based firmware
management operations may not work properly with some Web browsers. If you cannot
successfully perform HTTP-based firmware management operations with your Web browser, try
the TFTP-based method.
Upgrading the Firmware by HTTP
To upgrade the firmware of NI WAP-3701/3711 by HTTP:
1. Click Browse and then select a correct firmware .bin file. The firmware file path will be
shown in the Firmware file name text box.
2. Click Upgrade to begin the upgrade process.