National Instruments NI WAP-3711 - Manual (Page 37)

NI WAP-3701/3711 User’s Manual Web Console Configuration
3-23
NOTE The SNMP Authentication Failure trap is issued when using an incorrect community string to
manage the AP via SNMP and the SNMP MIB II OID, snmpEnableAuthenTraps, is enabled
(disabled by default).
SNMP
The SNMP (Simple Network Management Protocol) functionality can be disabled, and you can
specify the name (used as a password) of the read-only and read-write community. In addition, up
to 5 SNMP trap targets can be set in the SNMP Trap Table.
To specify a trap target :
1. Type the IP address of the target host.
2. Type the Community for the host.
Select the corresponding check box next to the IP address text box.