Nova Kool PRO 600E - Manual (Page 13)

ENGLISH
NovaJet PRO 600e
Quick Start 13
3 Press Utility/Access Cartridge to move the carriage back into the service
station. This ensures that the cutter blade is in the home position.
Filling the ink reservoirs
The printer can support long, uninterrupted printing runs because of the large
capacity of each of the four ink reservoirs. The ink reservoirs are located in the
printer's left side cover.
Note: When running at carriage speeds faster than the default, it is recom-
mended that ink levels in the reservoirs be no more than 300ml maximum.
➪ ➪ ➪ ➪ ➪
To fill the ink reservoirs
1 Open the cover on the left side of the printer to access the ink reservoirs.
Unscrew and remove the cap of one reservoir. Open only one reservoir at a
time to prevent contamination with other ink colors.
2 Make sure the ink color and type matches the reservoir and pour in the
ink. Do not add more than 400 ml of ink or fill higher than 1/2 inch from top
of the reservoir. Be sure to use the same type of ink (i.e., GA, GS, or GO)
in all the reservoirs and ink cartridges. Be sure there is no excess ink on
the inside of the reservoir cap. Replace the cap loosely on the reservoir -
do not overtighten.
3 Your printer comes standard with two complete sets of plumbing for easy
changeover between two ink sets. Each of these lines has color coded
quick connect fittings.
Be sure that each reservoir is connected to the
same color fitting. To change reservoirs, simply snap into the appropriate
fittings.
4 Repeat for the remaining reservoirs, then close the cover.
Installing the ink cartridges
The printer is designed to use only ENCAD PRO 600e series cartridges. It is not
compatible with NovaJet, NovaJet Pro, or NovaJet PROe cartridges. Use of other
cartridges may damage the printer and/or prevent it from printing and void the
warranty.
Be sure all cartridges and reservoirs use the same ink type; i.e., PRO
600e series GA, GS, or GO.