Nova Kool PRO 600E User Manual
Page 16
NovaJet PRO 600e
16 Quick Start
3
When ink is visible in the NovaPrime sight tube (should take 5-10 seconds),
remove the cartridge needle from the NovaPrime and quickly insert it into the
hole in the top of the ink cartridge. Be sure the needle is tightly connected
by turning the fitting clockwise until finger-tight.
4
Gently tighten the fitting (about 1/4 turn) to prevent air leaks. Do not over-
tighten. Wait 20 seconds for the ink pressure to stabilize.
5
Remove the cartridge from the carriage and remove the blue tape from the jet
area of the cartridge. CAUTION! Do not tilt the cartridge up higher than
a 30 degree angle. This could cause the cartridge to lose pressure.
6
Rotate the cartridge one complete revolution counterclockwise to ensure that
there are no twists in the ink delivery line.
Check for ink on the jet plate. Continuous bleeding of the jet plate indicates
a loss of vacuum in the cartridge or an air leak in the lines. A small amount
of ink can be cleaned off the jet plate by dabbing with a moist, lint-free cloth.
7
Insert the cartridge into the carriage.