Nova Kool PRO 600E - Manual (Page 6)

NovaJet PRO 600e
6 Quick Start
8 Attach the clamp for the grounding strap to the right lower rear edge of the
dryer assembly bracket and tighten the thumbscrew securely so that the
paint is penetrated.
9 Check to be sure that the media sensor is plugged in to the connector on
the right stand leg. You can swing the sensor mounting bracket away from
the printer if necessary when loading media.
10 To load media, slide the media roll over the feed roller. If you will be using the
takeup roller, mount an empty media core on the takeup roller before insert-
ing the roller into the stand. Mount the two rollers as shown below. Insert the
end of a roller into the space provided in the left roller support, then fit the
other end of the roller into the right support. Make sure the gear on the roller
is engaged with the gear on the support.