Nova Kool PRO 600E User Manual
Page 14
NovaJet PRO 600e
14 Quick Start
Note: Visually inspect each cartridge before installing. Make sure the blue tape
is intact on the jet area of the cartridge. (Do not remove the tape at this time as
the cartridge could leak! The tape will be removed later after negative pres-
sure has been established by priming the ink delivery lines.) Inspect the IC
chip on the cartridge. Make sure it is secure and in approximately the location
shown on the following figure. If any cartridge is damaged, contact your
authorized ENCAD distributor/dealer for return/replacement of the defective
cartridge.
➪
➪
➪
➪
➪
To install the ink cartridges
!
Do not touch the jet area or the flex contact area of the ink cartridge.
!
Work with only one ink color at a time to prevent contamination.
1
With printer power on, press Utility/Access Cartridges to move the carriage
to the position which allows replacement of the ink cartridges.
2
Cartridges are prefilled and preprimed. Remove the cartridge from the sealed
bag and remove the shipping cap.
3
Install the cartridge bottom first into the correct slot on the carrier. DO NOT
REMOVE THE BLUE TAPE FROM THE JET PLATE. Tilt the cartridge up
until it clicks into place. Make sure the cartridge is firmly seated.