Nova Kool PRO 600E - Manual (Page 22)

NovaJet PRO 600e
22 Quick Start
Paper axis calibration
Choosing Utility/Calibration/Paper Axis Test lets the printer draw a set of vertical marks
to calibrate the paper axis. To measure the marks laid down by the printer, you will need a
ruler or scale at least 33 inches (838.2 mm) long. The vertical marks should be exactly
33.00 inches (838.2 mm) apart. If the distance between the marks is different from that
shown on the display, you may adjust the printer by setting its values to match the
length or width you measured. Note: The Paper Axis Test should be performed every
time new media is loaded.
➪ ➪ ➪ ➪ ➪
To print the Paper Axis calibration test pattern
1 Load the printer with media that is at least 36 (91 cm) inches long (or the
media that you are going to run; you cannot load a 36" sheet and then run
the calibration from a roll feed because the line lengths will not match).
2 Press Utility/Calibration/Paper Axis Test.
The printer prints two marks.
3 Remove the media from the printer and measure the distance between the
marks. The distance between the marks should be exactly 33.00 inches
(838.2 mm).
4 If the measurement is not exactly 33.00 inches, select "Paper Axis" and
adjust the value to the measurement read on the scale.