Nx Networks NX series - Manual (Page 73)

Control keypad 73(86)
7
Contrast adjustment (P6.4.4)
In case the display is unclear adjust the contrast through the same procedure as that for the
timeout time setting (see above).
Backlight time (P6.4.5)
Giving a value for the Backlight time, can determine how long the backlight stays on before going
out. Select here any time between 1 and 65535 minutes or 'Forever'. For the value setting
procedure see Timeout time (P6.4.3).
7.3.6.5 Parameter copy
The parameter copy function is used when the operator wants to copy one or all parameter groups
from one drive to another. All the parameter groups are first uploaded to the keypad, then the
keypad is connected to another drive and then the parameter groups are downloaded to it (or
possibly back to the same drive).
Before any parameters can successfully be copied from one drive to another the drive has to be
stopped when the parameters are downloaded to it:
The parameter copy menu (S6.5) embodies two functions:
Upload parameters to keypad (To keypad, S6.5.1)
This function uploads all existing parameter groups to the keypad provided that the drive is
stopped.
Enter the To keypad page (S6.5.1) from the Parameter copy menu. Push the right arrow menu
button to enter the edit mode. Use the Browser buttons to select the option All parameters and
press the Enter button . Wait until 'OK' appears on the display.
Figure 7-19. Parameter copy to keypad
P1 "
P4
RE ADY
I/Oter m
RE ADY
I/Oter m
REA DY
I/Oterm
enter
READY
I/Oterm
RE ADY
I/Oter m
Copy Parameters Up to keypad Up to keypad
Select
CANCEL
CONFIRM
Up to keypad
Wait...
Up to keypad
OK
All param.