Nx Networks NX series - Manual (Page 74)

74(86) Control keypad
7
Download parameters to drive (From keypad, S6.5.2)
This function downloads one or all parameter groups uploaded to the keypad to a drive provided
that the drive is in STOP status.
Enter the From keypad page (S6.5.2) from the Parameter copy menu. Push the right arrow menu
button to enter the edit mode. Use the Browser buttons to select either the option All parameters
or Application parameters and press the Enter button . Wait until 'OK' appears on the display.
The procedure to download the parameters from keypad to drive is similar to that of from drive to
keypad. See above.
Parameter sets (S6.5.3)
The NX frequency converter features a possibility for the user to store and load two customised
parameter sets (all parameters included in the application) and to load back the factory default
parameter values.
On Parameter sets page (S6.7), push the right arrow menu button to enter the Edit menu. The text
Select begins to blink allowing you to choose any of the storing or loading functions with the
Browser buttons . You can store or load two customised parameter sets or load back the factory
defaults. Confirm with the Enter button . Wait until 'OK' appears on the display.
Figure 7-20. Storing and loading of parameter sets
Parameter backup (P6.5.4)
On this page the user can activate or inactivate the parameter backup function. Enter the edit
mode by pressing the
right arrow menu button . Choose Yes or No with the Browser buttons .
When the Parameter backup function is activated the NX control keypad makes a copy of the
parameters of the presently used application. When applications are changed, the user will be
asked if they wish the parameters of the new application to be uploaded to the keypad. For this to
happen, push the
Enter button . If a copy is required of the parameters of the previously used
application saved in the keypad push any other button. The user will be able to download these
parameters to the drive following the instructions given in chapter 7.3.6.5.
REA DY
I/Oterm
READY
I/Oterm
enter
READY
I/Oter m
RE ADY
I/Oterm
OK
Parameter sets
Select
Parameter sets
CANCEL
CONFIRM
Parameter sets
Wait...
Parameter sets
Store Set1