Set stop bits, Serial interface control lines, Òserial interface control – Nortel Networks CTA 500dm User Manual

Page 56: And if &d is either 1, 2 or 3 (see the, Òserial interface control linesó, For the commands), For more details), And if &d is either 1, 2 or 3 (see, Òserial interface control linesó on, Immediately before the indication if &c is 1 (see

Advertising
Set stop bits, Serial interface control lines, Òserial interface control | And if &d is either 1, 2 or 3 (see the, Òserial interface control linesó, For the commands), For more details), And if &d is either 1, 2 or 3 (see, Òserial interface control linesó on, Immediately before the indication if &c is 1 (see | Nortel Networks CTA 500dm User Manual | Page 56 / 86 Set stop bits, Serial interface control lines, Òserial interface control | And if &d is either 1, 2 or 3 (see the, Òserial interface control linesó, For the commands), For more details), And if &d is either 1, 2 or 3 (see, Òserial interface control linesó on, Immediately before the indication if &c is 1 (see | Nortel Networks CTA 500dm User Manual | Page 56 / 86
Advertising
See also other documents in the category Nortel Networks Hardware: