Nortel Networks CTA 500dm - Manual (Page 40)

40 AT commands
CTA 500 dm On Line Guide P0873832 Issue 05
Verbose Control
The Verbose Control Command
V[value]
controls the indications sent by the CTA 500dm. A value of 0
instructs the CTA 500dm to send only numeric indications. A value
of 1 instructs the CTA 500dm to send full indications. The default
value is 1.
The numeric responses and indications are shown in ÒNumeric
CTA 500dm responsesÓ on page 83 .
Result Codes
OK Appears when the value is supported.
ERROR Appears when the selected value is unrecognized or is not
supported.
Result Code Suppression Control
The Result Code Suppression Control Command
Q[value]
controls the transmission of result codes by the CTA 500dm.
Possible values are shown below.
Result Codes
OK Appears when the value is 0.
ERROR Appears when the value is unrecognized and the previous
value was 0.
none Appears when the value is 1 and result codes are suppressed.
none Appears when the value is unrecognized and the previous
value was 1.
Value Use
0 result codes sent (default)
1 result codes not sent