Nortel Networks CTA 500dm - Manual (Page 77)

Appendix 77
P0873832 Issue 05 CTA 500 dm On Line Guide
7. Do not allow anything to rest on the power cord. Do not locate
this product where the cord will be abused by persons walking
on it.
8. Do not overload wall outlets and extension cords as this can re-
sult in the risk of fire or electric shock.
9. Never spill liquid of any kind on the product.
10. To reduce the risk of electric shock, do not disassemble this
product, but have it sent to a qualified service person when ser-
vice or repair work is required.
11. Unplug this product from the wall outlet and refer servicing to
qualified service personnel under the following conditions:
a. When the power supply cord or plug is damaged or frayed.
b. If the product has been exposed to rain, water or liquid has
been spilled on the product, disconnect and allow the product
to dry out to see if still operates; but do not open up the
product.
c. If the product housing has been damaged.
d. If the product exhibits a distinct change in performance.
12. Avoid using telephone equipment during an electrical storm.
There may be a remote risk of electric shock from lightning.
13. Do not use the telephone equipment to report a gas leak in the
vicinity of the leak.
14. CAUTION: To eliminate the possibility of accidental damage
to cords, plugs, jacks, and the telephone equipment, do not use
sharp instruments during the assembly procedures.
15. Save these instructions.
CANADIAN AND US REGULATIONS
NETWORK CONNECTION (Canada, United States)
This device complies with the requirements of Part 68 of the FCC
Rules and Industry Canada CS03, Issue 8, for connection to the Host
equipment (Norstar or Companion equipment) only, and may not be
connected directly to the Public Switched Telephone Network
(PSTN).
FCC registration number: This equipment complies with Part 68,
Rules and Regulations, of the FCC for connection to Host
equipment (Norstar or Companion equipment) and may not be
connected directly to the Public Switched Telephone Network