Nortel Networks SRG50 - Manual (Page 49)

Chapter 4 CS 1000 considerations 49
SRG50 Configuration Guide
To enter the MOTN and BUID
1 In Element Manager, navigate to Configuration > Resources > Survivable Remote
Gateway.
2 Select the S1000 IP Terminal Details tab (see the figure S1000 IP Terminal Details panel on
page 50).
3 Refer to the numbers and models recorded in the table IP telephone numbers and models on
page 47.
4 Select the required DN.
5 Press the Modify button.
6 Enter the MOTN and the BUID in the appropriate fields.
To redirect the telephone to the main office call server
1 In Element Manager, navigate to Configuration > Resources > Survivable Remote
Gateway.
2 Select the S1000 IP Terminal Details tab (see the figure S1000 IP Terminal Details panel on
page 50).
3 Select the DN of the telephone to be redirected.
4 Press the Redirect Set button.
Firmware
Version Read-only Updated by the main office when a terminal is sent back to the SRG for
firmware upgrade purposes. The field specifies the firmware version
required by the main office.
MOTN XXX Required for telephone redirection.
The field is the main office TN associated with the IP telephone.
BUID CDP network: <DN>
UDP network: <VoIP access
code> + <LOC> + <DN>
Required for telephone redirection.
The field represents the dialable number of an IP telephone at the SRG
when it is called from a phone located at the main office or another
branch office.
The BUID at the SRG must be the same as the BUID at the main office.
MO TPS Read-only This field echoes the address of the main office terminal proxy server
when the IP telephone is redirected.
Note: The SRG DNs must be configured before the following
procedures can be undertaken. See
Telephone (DN) records
configuration on page 56.
Table 10 SRG S1000 IP Terminal Details fields (Sheet 2 of 2)
Field Values Description