Eizo 531L - Manual (Page 100)

English
100
11. REFERENCE
11. REFERENCE
11-1. Attaching an Arm Stand
The eClient can be used with an arm stand by removing the tilt stand and attaching the
arm stand to the terminal.
NOTE
• Use an arm stand that satisfies the following.
- When using the eClient with an arm stand, the arm stand must be VESA
approved :
Use an arm stand with a 75 mm x 75 mm hole spacing on the arm mounting pad.
Use an arm stand that is able to support an object weighing 8.0 kg.
A GS approved arm stand.
- Use an arm stand with sufficient stability (mechanical firmness) to support the
weight of the monitor.
- Use an arm stand remaining that position where it is manually moved.
- Use an arm stand with the ability to tilt the monitor forward and backward.
• Please connect cables after attaching an arm stand.
Setup Procedure
1.
Lay the eClient down as shown below. Do not scratch the panel.
2.
Remove the stand by loosening the screws (M4 x 16 mm).