Eizo 531L - Manual (Page 92)

English
92
8. TROUBLESHOOTING
8. TROUBLESHOOTING
This page presents problem that can be corrected by the user. If a problem persists even
after applying the suggested remedies, contact an EIZO dealer.
Problems Points to check with possible solutions
1. No picture is displayed on the screen. Check if the power is OFF.
Check brightness setting. Minimum settings
will cause screen to be blank.
Try pressing a key on the keyboard, or clicking
the mouse. (The monitor may be in a power
saving mode.)
2. The following messages appear on screen
after the power is on:
(The operation automatically starts
up after the message disappears.)
*
“WARNING
No Keyboard Connected”
*
“WARNING
No Mouse Connected”
Check if the cable of the keyboard is securely
connected to the proper connector.
Check if the cable of the mouse is securely
connected to the proper connector. (In use of a
stylus or a finger as an input device, “No
Mouse Connected!!” caution does not effect
your operation.)
Turn off the power, and turn it on a few seconds
later.
3. Input devices (such as a keyboard, a
mouse, a stylus) does not work properly.
Solution on a mouse or a kyboard
Check if the cable of the keyboard or the mouse
is securely connected.
Check if the cable of the keyboard or the mouse
is connected to the proper connector.
Solution on a stylus ( 531LT -GR)
The touch panel may not be calibrated properly.
Please recalibrate the touch panel (see page 65).
Solution on a keyboard, a mouse, and a stylus (531LT-
GR)
Check if the network cable or the modem is
securely connected. (To make sure the ethernet
cable is connected securely, check if one of the
indicators on the ethernet connector turns
green.)