NETGEAR PS100 - Manual (Page 110)

NetGear Print Server Manual
101
Protocol computers. The factory default is enable.
TCP/IP Tab
This tab allows configuration for the TCP/IP network protocol.. For further information about TCP/IP,
refer to Chapter
Figure 8-5 TCP/IP Tab Window
TCP/IP Tab Fields
Field Description
DHCP This field allows you to enable or disable the print server's ability to get its IP address from a DHCP
(Dynamic Host Configuration Protocol) server. When disabled, you can provide a fixed IP address in the
following fields.
IP Address This IP address is assigned to the print server. If you have a private LAN and do not plan to connect to the
TCP/IP-based internet, NETGEAR recommends that you use the address from the IETP-designated
private addresses (for example, 192.168.x.x or 10.x.x.x).