NETGEAR PS100 - Manual (Page 83)

NetGear Print Server Manual
74
6-4 PSTool Utility CONFIG File Format
The entries of the config file are listed and described in table 7.1. This example is for the 3 port model
of the NETGEAR Print Server.
PSTool Utility Config File Entries
Entry inConfig File Description
begin CMD
Do not change this line.
0001 Device Name:
xxxxxxxx
Replace xxxxxxxx with the desired device name. The Device Name will initially be the Default Server
Name. The Default Server Name is shown on a sticker on the base of the device. The Device Name can
be changed, but the new name must not exceed 16 characters in length
3000 Apple Zone: *
The default value "*" allows all AppleTalk zones to access the Print Server's printers. To restrict access
to a particular zone, replace the * with the desired zone name.
3101
AP_PCOMM1: No
3102
AP_PCOMM2: No
3104
AP_PCOMM3:
These settings determine whether the port uses ASCII or Binary Communication Protocol. Enter No for
ASCII or Yes for Binary. The lines corresponds to port 1, 2 and 3 of the print server.
Binary communication is twice as fast as ASCII
ASCII communication is more reliable
The computer, Print Server and printer MUST all be configured to use the SAME protocol.
9002
Do not change this line.
Note: NETGEAR does not support PS101 Print Server for AppleTalk printing environment.